Installation Location And Line Description
Step 1：Remove the lens cover and the double-sided tape of the product
Note：Clean The Windshield Before Fixing The Camera
Step 2：Install The Camera Tightly In The Middle Of The Windshield Behind The Rear View Mirror.For best results, it is recommended to install the product in the middle and left 5 cm section.
Step 3：Line Connection
Please connect the 6-star power cord to the OBD adapter (optional) or the 6-star analog cable. More detailed wiring information: see manual 2-2 OBD adapter installation and 2.3 analog line installation
Note：If you want to connect speed and turn signals, you need computer debugging.
Step 4：Initial Setup: Please Refer To The Setup Process Carefully
Install The OBD Adapter
Note：Use The Obd Adapter For Installation Only If The Vehicle Has A Can-bus Signal.
Step 1：Connect The OBD Adapter To The 6-star Power Cord
Step 2：Connect The OBD Adapter To The Vehicle OBD Diagnostic Interface
Step 3：Start The Vehicle And Check If The Middle Led Is Green
Step 4：Turn The Left And Right Turn Signals On/off To Check If The Left And Right Leds Are Flashing.
Step 5：After Completing The Fourth Step, Check Whether The Functions Are Running Normally.
Note：
Usually, The Obd Interface Is Located Below The Driver's Seat Or To The Shift Lever Position.
Please Connect The Connector Correctly. If The Connection Is Improper, It Will Cause Product Failure Or Damage.
Analog line installation
Step 1：Connect A Four-star Analog Line To A Four-star Interface
Step 2：Connect The Left And Right Turn Signal Lines To The Vehicle Turn Signal
Step 3：Connect Speed Signal To Vehicle Speed Pulse Signal Interface Or Speed Sensor
Step 4：Connect The Power Cord To The 6-star Interface
Step 5：Connect Power, Engine And Ground Line To The Vehicle-related Interface
